Reliable 100IS Use and Care Manual download pdf (Page 12)

FILLING THE BOILER DURING USE

Turn the boiler off pressing the switch (L) before unscrewing the cap (B).

Press the steam button (D) on the iron and allow all the steam to escape. The iron

must not be on its stand during this operation.

Switch off the iron by pressing the (O) button.

Disconnect the power supply cable from the outlet (Fig. 2). Let the appliance

to cool down for a few minutes. Rotate the boiler cap (B) counter-clockwise

very carefully and wait for the residual steam to stop hissing before emptying it

completely (Fig. 8).

Top up the boiler using the funnel (J) provided (Fig. 3).

Replace the cap (B) and screw it in a clockwise direction, ensuring that it is

completely tight.

WARNING: Never unscrew the cap of the boiler while the appliance is connected to

an electrical outlet or when there is still pressure inside. Never unscrew the cap of

the boiler while you are ironing. If the iron has not been used for a long time, it is

advisable to keep it in a horizontal position and press the steam button (D) for 30

seconds in order to clean the inner dispensing lines of the iron. Do not carry out

this operation when the iron is on its stand (I). For a short ironing session, it is not

necessary to ﬁll the boiler completely. In fact, less water in the boiler will reduce

the waiting time, and consequently electric energy consumption.

VERTICAL IRONING

You can use the jet of continuous steam for ironing hanging fabrics. This special

ironing procedure serves to remove creases from curtains, fabrics, etc... Set the

ironing temperature by turning the adjustment knob (F) past the symbol (•••). Put

the curtain or fabric in the position you would like to iron it vertically and press

the steam button.

WARNING: Do not direct the steam jet towards people, animals or iron clothes

when they are being worn, as this could be dangerous.

DRY IRONING

To iron dry - i.e. without steam - all you have to do is turn the iron on by pressing

the switch (O) after connecting it to the power supply. Place the steam adjustment

knob on minimum and turn the thermostat knob (F) to the desired temperature.

Do not press the steam button.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

No comments

Reliable 100IS Use and Care Manual Page 12